![]() ![]() If I set on loopback interfaces, I cannot get out to the head office router so I think this is the correct configuration, no assist or working configs from BT so working blind.īT will only route the 10.1.2.0/24 subnet for this particular branch, if I try to use NAT, it will not carry across the MPLS network and gets dropped in the MPLS circuit. MPLS Dialler interface has been configured with an IP address of 10.1.2.1, this appears to be the only way I can announce the network into MPLS. I have now hit a stumbling block whereby I don't know how to allow branch office devices (only 1-2 desktop PC's and a VOIP phone) to connect to our head office resources.MPLS, BT, Routing, Subnetsīranch office routers are Cisco ISR 877VA's with 4 FA interfaces which I will be using to connect the various devices. I am in a position where I have the head office router configured, and a branch router able to ping our head office resources through our Watchguard firewall, progress! ![]() I am relatively new to the Cisco world and have been tasked with setting up a BT MPLS network! Yipee! ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |